where in configuration files can i modify default gateway in hp-ux11iv3
Use the
#set parms_initial
command to change default gateway ip .. It presents you with a network configuraton screen in CLI mode . Make changes as per ur req
@ultimatix
please take care of what you type
I think you meant
#set_parms initial
set_parms options
initial
This allows the user to sequentially invoke all the sub-areas mentioned below. The user can configure multiple interfaces which are physically connected to the network using the Terminal User Interface (TUI). A # in the user interface field indicates a lan which is not physically connected to the network. If lan interfaces are configured as DHCP, the options ip_address and addl_netwrk are skipped.
addl_netwrk
Set the route mask (which defines the network and local subnet portions of a network address), set the routing gateway, and define access to the Domain Name System (DNS) and Network Information Service (NIS).
First-boot: These changes take effect immediately, without a reboot, because
set_parms
starts networking after setting the parameters.
Non-first-boot: A reboot is required for all of these changes to take effect.
which in turns affects
#/etc/rc.config.d/netconf
Sorry mate:)
The best and esiest way is to use SAM and then go to NETWORKING!
you can also use set_parms command
I hope this will help you!
Dali
Always save these two files and "diff" afterwards because SAM can remove fully qualified host name which affects "sendmail" and the "diff" will make sure that you only changed what you wanted to change.
/etc/hosts
/etc/rc.config.d/netconf