Sun Blade 150 will not boot off harddrive after install of solaris 10

UNIX Solaris
1

Hello,

I cant get my blade box to boot off the harddrive after installing solaris 10.I can get to a root prompt after issuing "boot cdrom -s".I tried booting off disk0 and disk1,but I get "the file just loaded does not seem to be executable".Thanks for any help.:wall:

2

what is the output of:

ok probe-scsi-all
ok probe-ide
ok show-disks

from ok prompt?
compare the output to the devalias settings

1 Like
3

Output of probe-scsi-all is:

/pci@f,0/pci@5/pci@2/SUNW,isptwo@4

Output of probe-ide is:

Device 0 ( Primary Master )
ATA Model: Maxtor 6E040L0
Device 1 ( Secondary Master )
Removable ATAPI Model: TSSTcorp CDW/DVD TS-492C

Output of show-disks is:

a) /pci@1f,0/pci@5/pci@2/SUNW,isptwo@4/sd

b) /pci@1f,0/ide@d/cdrom

c) /pci@1f,0/ide@d/disk

4

and did you compare it to the output of devalias? this string "/pci@1f,0/ide@d/disk" should be inside your "disk" alias...

Sun Blade 150
    PCI Slot #1                 /pci@1f,0/<device>@2,*
    PCI slot #2                 /pci@1f,0/<device>@1,*
    PCI Solt #3                 /pci@1f,0/<device>@3,*
    primary ide master          /pci@1f,0/ide@d/dad@0,0      (default boot)
    primary ide slave           /pci@1f,0/ide@d/<dev>@1,0    (default cdrom)
    secondary ide master        /pci@1f,0/ide@d/sd@2,0       
    secondary ide slave         /pci@1f,0/ide@d/<dev>@3,0
    environmental monitor &
       card reader              /pci@1f,0//pmu@3/<path>
    proms                       /pci@1f,0/ebus@c,3/<usb device>
    internal graphics           /pci@1f,0/SUNW,m64B@13
    USB ports                   /pci@1f,0/usb@c,3/<usb device>
5

Hi Duke,

Thanks for the reply.

The alias for "disk" is /pci@1f,0/ide@d/disk@0,0.

Ive tried everything to get it to boot.Installing solaris again,installing a new bootblock and the command "set-defaults".I still get the same error.Could it possible that I need to update openboot my revision is 4.6.