hello
i had soloaris 8 installed . at the beggining it sees my network
card( intel i815/82559 onboard)(my mainboard is GA-8IRXP);
but during the installation when I fill the ip address and the dns
at the end that i should confirm it says:
no dns find (i'm sure about the dns ...192.9.9.3,80.82.224.10)
but i accepted it anyway,ok?
but after the installation i can't ping (no answer),telnet
but it pings it's ip(127.0.0.1 or 80.82....)ok?
and i know how to work with ifconfig and conf files in /etc
and i'm really angry about it and have no idea what to do ,cuz if already tested lots of things (changing lan card,.....)
by the way on this machine when i install linux 7.2 it works perfectly.
I am not totally sure of what your problem is but....
DNS - to set up client side DNS vi /etc/resolv.conf
(change it for your needs). The nameserver IP address is whichever system provides the DNS (your primary and secondary servers). You can only list 3 - it won't use more than the first three even if the first two are not working. Example:
Do a netstat -r and netstat -nr. Insure that what you believe is your routes are there. Check that you have a default route. If not, add the default route to /etc/defaultrouter.
When installing Solaris, usually it's best not to bother with the Name Services and set them up later (it never seems to find the servers and wastes your time on installation).
thanks
but what bothers me is not the DNS problem . and during the
installation I ignore it but even after the installation i'm unable
to ping or actually see anywhere not even a PC in my LAN.
The interface is configured(i think so) cuz when i run the command
ifconfig iprb0 , i get the correct ip address and things like that.
If you have any idea please let me know cuz i do want to have it fixed.
I've tried the netstat command and i got these: #netstat -nr
routing table ipv4
destination gateway flags REF USE interface
80.82.226.0 80.82.226.90 U 1 45 iprb0
224.0.0.0 80.82.226.90 U 1 0 iprb0
127.0.0.1 127.0.0.1 UH 2 6 lo0
everything seems ok ,doesn't it?
(my ip is valid you check is yourself)
thank you very much
yes you were right cuz when i check it yesterday there was no
defaultrouter.but i had it before i don't know what happened to my solaris at this time ( it was my 10th time during this week but only on this installation there was no default router )
but forget it any way cuz i tried something else today.
i installed it on two other machine ( completely different hardware). one on a Proliant ( dual processor , SCSI hard disk and...)but it didn't detect the hard disk i don't know why.
so i tried installing it on another PC(pentium III 1G,3com lan card and...)
you don't believe me but it worked on this machine without any problem.I still don't know what the problem was with my own machine!!!!( cuz i did the same job)
but there is somethin i want to know :
i my pentium 4 machine , solaris detected the lan card at the beginning but during the installation where you choose whether you want " networked or non-networked"; but default the box non-netword was checked.
but on the pentium III the networked was checked - as expected.
if the problem is my lan card so how did it detect it ?
if not what is the reason ?
if you have any idea please let me know