-> show faulty
Target | Property | Value
------------------------------------------+--------------------------------------------------+------------------------------------------------------------------------
/SP/faultmgmt/0 | fru | /SYS/PS1
/SP/faultmgmt/0/faults/0 | class | fault.chassis.power.fail
/SP/faultmgmt/0/faults/0 | sunw-msg-id | SPT-8000-MJ
/SP/faultmgmt/0/faults/0 | component | /SYS/PS1
/SP/faultmgmt/0/faults/0 | uuid | c2885a5d-06b7-6bfd-9072-d9a18e399636
/SP/faultmgmt/0/faults/0 | timestamp | 2019-10-29/04:47:03
/SP/faultmgmt/0/faults/0 | fru_part_number | 300-2235-03
/SP/faultmgmt/0/faults/0 | fru_serial_number | B70104
/SP/faultmgmt/0/faults/0 | fru_manufacturer | Delta Electronics
/SP/faultmgmt/0/faults/0 | system_manufacturer | Oracle Corporation
/SP/faultmgmt/0/faults/0 | system_name | SPARC T4-1
/SP/faultmgmt/0/faults/0 | system_part_number | 31940932+4+1
/SP/faultmgmt/0/faults/0 | system_serial_number | AK00118201
/SP/faultmgmt/0/faults/0 | chassis_manufacturer | Oracle Corporation
/SP/faultmgmt/0/faults/0 | chassis_name | SPARC T4-1
/SP/faultmgmt/0/faults/0 | chassis_part_number | 31940932+4+1
/SP/faultmgmt/0/faults/0 | chassis_serial_number | AK00118201
/SP/faultmgmt/0/faults/0 | system_component_manufacturer | Oracle Corporation
/SP/faultmgmt/0/faults/0 | system_component_name | SPARC T4-1
/SP/faultmgmt/0/faults/0 | system_component_part_number | 31940932+4+1
/SP/faultmgmt/0/faults/0 | system_component_serial_number | AK00118201
/SP/faultmgmt/0/faults/0 | detector | /SYS/PS1/PWROK
/SP/faultmgmt/0/faults/0 | diagnosis_engine | fdd 1.0
I plugged both power cables in both power supply. When I unplugged each power cable one by one, the SPARC T4-1 machine keep running. However, show faulty command shows below message. (I have also attached the picture of both power supply)
Perfectly normal.
When you unplug the PS, a fault is generated.
You can clear the fault, after you plugged it back in and it shows everything is ok.
Regards
Peasant.
1 Like