Hi All,
I have my SC setup as attached below but I am having problem accessing the port thru network. sc0 was accessible only after i failed over the configuratios to sc1 (now then sc1 was not pingable :(). Just wondering is there anything wrong with my sc settings? Appreciate your advice.
Network settings: 10Mpbs/Half Duplex
The system controller is configured to be on a network.
Network settings: static
Hostname: sc0
IP Address: 128.230.31.149
Netmask: 255.255.255.0
Gateway: 128.230.31.1
DNS Domain:
Primary DNS Server:
Secondary DNS Server:
Connection type: telnet
Idle connection timeout : No timeout
Loghost for Platform: 10.0.0.1
Log Facility for Platform: local0
SNTP server: 0.0.0.0
SNMP Agent: disabled
Chassis Description: Sun Fire 4800
Chassis Contact: adminstrator
Chassis Location: 10F IT Dept
ACL for Domain A: SB0 SB2 SB4 IB6 IB8
ACL for Domain B: SB0 SB2 SB4 IB6 IB8
ACL for Domain C: SB0 SB2 SB4 IB6 IB8
ACL for Domain D: SB0 SB2 SB4 IB6 IB8
Chassis HostID: 83041764
PROC RTUs installed: 0
PROC Headroom Quantity: 0
PROC RTUs reserved for domain A: 0
PROC RTUs reserved for domain B: 0
PROC RTUs reserved for domain C: 0
PROC RTUs reserved for domain D: 0
SC POST diag Level: min
SC Failover: enabled and active.
Logical Hostname: 10.0.0.4
Chassis is in single partition mode.
UltraSPARC IV+ is not supported in domain A
Frame information is not available.
Many thanks.