Reg Error Message during LAN Drivers installation

UNIX Solaris
1

Hi Friends, I Tried to install the LAN Drivers Manually in my Intel Home PC, This was the Error i got During the Installation can i know what is the cause to get this Error.

pkgadd: ERROR: unable to create symbloic link from </var/sadm/pkg/RTL8139/predepend> to </usr/options/RTL8139.name>
Installation of <RTL8139> partially failed. Thanks in Advance.

2

Is this directory created /usr/options/ ?

3

Hi I had downloaded LAN Drivers from Realtek Website and i followed the instructions mentioned in the document but i dont understand what is scoadmin please if any one can explain what it mean

This is the Document from Realtek:-
SCO UnixWare 7.x

Introduction:
-------------
This document describes the procedure to install the SCO UnixWare 7
driver for Realtek RTL8139C+/8139/810x Family Fast Ethernet Adapter.

Location of Driver: \uw7\rtspkg.tar

Installing driver procedure on SCO UnixWare7 :
-----------------------------------------
Before you start with the installation process, make sure that the
SCO UNIX system is properly installed. Similarly, your adapter should
also be properly installed in your machine.

 1. Installation Diskette in DOS format.
    Put RTL SCO UnixWare Driver diskette to floppy A: and use doscp
    command to copy RTL SCO UnixWare Driver into UNIX's directories.
    NOTE: In UnixWare 7.1.1, you must install the "mtools" package included
          within the OS and use "mcopy" instead of "doscp".

   \# cd /
   \# doscp A:uw7/rtspkg.tar  /tmp

 2. Run 'tar' utility to extract the driver.

   \# cd /tmp
   \# tar -xvf rtspkg.tar

 3. Run 'pkgadd' utility to add the driver software to system.

   \# pkgadd -d /tmp/pkg
     =&gt; Select "RTL8139" to add the driver package to the system.
     =&gt; quit

 4. Use 'scoadmin' utility to add adapters.

   \# scoadmin
     =&gt; Select "Networking" item from the item list and press enter.
     =&gt; Select "Network Configuration Manager" item from the item list
        and press enter.
     =&gt; Select "Add New Lan Adapter" menu item from "Hardware".
     =&gt; Select the Realtek RTL8139C\+/8139/810x item from the item list.
     =&gt; Add protocol\(s\) to the adapter.

 5.  Return to the command prompt.

 6.  Shutdown the system and reboot.

 NOTE: 1. If you want to install more than one network adapter, you
          should do the 4th, 5th, 6th steps above for each network card
          separately.
       2. This driver can support up to four network adapters.
4

looks like you have the SCO version of the drivers. you need the sol10 drivers.