Hello,
After installing on P6 which is POWERVM IVM VIOS enabled (VET CODE D21C77ACD9229817CA1F00002C10004164 )
i get this message
"I/O hosting requires a hosting partition - boot not permitted".
HMC was connected to the machine
then HMC was removed through ASMI
Searching on google found this
But doesn't mention solution,
how can one solve "mismatch between the LPAR type and the booting image"
hmm, just to make sure i understand the situation correctly:
On the case of 3 "yes"es: you need to install the LPAR anyway, so boot it via NIM methods (mksysb+spot). You can the select the disk to install to and this disk will be wiped first, so the VIOS image will go away. Only then (after installation) you can boot from the disk.
I hope this helps.
bakunin
Googled it, and many users have similar issues and no solution is posted:
here is the solution:
1) Check the firmware
2) Check if the machine has VET VIOS POWERVM IVM key license enabled
3) HMC should be disconnected from the machine
CoD Capability Settings
Capability bit information Capability bit status/count
0 AIX allowed (license needed) False
1 AIX allowed (license not needed) True
2 RPA I/O hosting True
3 AIX diagnostics True
4 Subprocessor partitioning True
5 LPAR creation allowed True
6 3D work-station graphics card OK True
7 External GX busses OK True
8 i5/OS partitions allowed True
9 Limit the number of i5/OS processors allowed False
10 Reserved False
11 100% interactive False
12 Memory bandwidth False
16 Extreme boot capability False
31 HV I/O allowed True
32 Number of 5250 users 0
MAKE SURE TO REMOVE HMC from ASMI
Hardware Management Consoles
√ Connection Id Address ( IP ) State
7042CR4*107A0CB Not Applicable Temporary Disconnect
Hardware Management Consoles7042CR4*107A0CB: Successfully disconnected
Operation completed successfully
power down and power on the system and it should work