how to set IP for iLO in HP server first time
thanks to all
check this
also found at
http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00553302/c00553302.pdf
page 19
Configuring the IP address
This step is necessary only if you are using a static IP address. When using dynamic IP addressing, your DHCP server will automatically assign an IP address for iLO 2. HP recommends using DNS or DHCP with iLO 2 to simplify installation
To configure a static IP address, use the iLO 2 RBSU with the following procedure to disable DNS and DHCP and configure the IP address and the subnet mask:
- Restart or power up the server.
- Press the F8 key when prompted during POST. The iLO 2 RBSU runs.
- Select Network>DNS/DHCP, press the Enter key, and then select DHCP Enable. Press the spacebar to turn off DHCP. Be sure that DHCP Enable is set to Off, and save the changes.
- Select Network>NIC>TCP/IP, press the Enter key, and enter the appropriate information in the IP Address, Subnet Mask, and Gateway IP Address fields.
- Save the changes.
- Exit iLO 2 RBSU. The changes take effect when you exit iLO 2 RBSU.
regards