HP-UX installation and setup bootdisk

UNIX HP-UX
1

Hi everyone,

I am very new to HP-UX

zx600 workstaton had a bad boot disk and need to replace it.
After done installing HP-UX 11.31 (with LVM), how do I make it boot to the bootdisk? it stops at EFI shell.

Any hints will be appreciated.

Thanks,
Lily.

2

Sorry, I managed to do it once, but this is sooo long ago.
I remember had to visit the HP support Web, but my URL is outdated.
Maybe the following note is helpful:

If boot config is lost:

Shell> fs0:
fs0:> hpux

and system will boot

xxxxx001.domain:
Aug 10 17:08:15 xxxxx001 vmunix: 0/0/2/0.0.0.0 sdisk
Aug 10 17:08:15 xxxxx001 vmunix: 0/1/1/0.0.0 sdisk
Aug 10 17:08:15 xxxxx001 vmunix: 0/1/1/0.1.0 sdisk
setboot
Primary bootpath : 0/0/2/0.0.0.0
HA Alternate bootpath : 0/1/2/0
Alternate bootpath : 0/1/2/1

Autoboot is ON (enabled)

lvlnboot -v
        /dev/dsk/c2t1d0 (0/1/1/0.1.0) -- Boot Disk
        /dev/dsk/c2t0d0 (0/1/1/0.0.0) -- Boot Disk

set bootpath to THIS.
1 Like
4

Thanks a lot MadeInGermany!

I missed : after fs0 :frowning: