Can not recognize network adapter SCO UNIX in HP z400

UNIX SCO
1

hi .I've installed an operating system SCO in HP Z400 and network cards ZyXEL model FN312 with Chipset RTL8139D put it on .network card installed but do not display network card with command ifconfig -a in list and just show loopback.

show message  :
dlpid:unable to open network adapter driver (/dev/mid/r9e0)
dlpid: no such file or directory

please Help me .
tanks

2

What version of sco. And where did you get the driver for the nic?

---------- Post updated at 08:20 PM ---------- Previous update was at 08:45 AM ----------

These drivers may work for the on board Broadcom network card.
For 507:
Xinuos Inc. | Support | Update | Download | Support

For 600:
Xinuos, Inc. | Support | Update | Download | Release

1 Like
3

version Of Sco 5.7 .
Which driver do I download sites?

For 507:
Xinuos Inc. | Support | Update | Download | Support

tanks

4

osr507mp5
oss674a
oss672a
bnxii_4.6.0
bcme_10.4.3

1 Like
5

thanks for your help
After installation, the following message at boot :

dlpid : unable to open network adapter drive (/dev/mdi/bnxii0)

dlpid : no such file or directoy

this file

/dev/mdi/bnxii0

exists

6

What steps did you take after installing all that software?
Some possibilities:
The nic is disabled in the CMOS.
netconfig requires that you input the PCI parameters, and you have left them at the default 0,0,0.
The nic is defective.

1 Like
7

hi
The nic is Enabled in the CMOS.
NIC is not broken.
How can I find Number pci parameter
tanks .

8

What happened when you ran netconfig?

1 Like
9

just show loopback
picture show the message in boot

10

Well, there's definitely a discrepancy between the adapter named in post#5 ( /dev/mdi/bnxii0 ) and the one you show in the screenshot ( /dev/mdi/r9e0 )!
Which is the one in question?

1 Like
13

I have two network cards and got the same message
Zyxel RTL8139D & Boardcam Netxtream

14

Can you show us a screen shot of netconfig?

15

yes.tanks

16

yes .i send picture

17

You haven't added the Broadcom device yet? Is this because you tried, and the device is not either of the ones for which there is a SCO driver.
HP does not have any SCO drivers for the z400.
For the Realtek card you probably have to supply the PCI Slot number, the Bus Number and the Device Number. These are sometimes available in the CMOS, or are displayed during POST.

1 Like