hi guys,
i'm new so don't bite too hard.
having a problem booting up a V210 running sol9 on after a power outage...
an init5 was done but not a init0 before the power cut... so now when booting up it gives the ff:
SC Alert: Host System has Reset
Probing system devices
Probing memory
Probing I/O buses
Sun Fire V210, No Keyboard
Copyright 1998-2004 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.16.2, 2048 MB memory installed, Serial #67021389.
Ethernet address 0:3:ba:fe:aa:4d, Host ID: 83feaa4d.
Rebooting with command: boot
Boot device: /pci@1c,600000/scsi@2/disk@0,0:a File and args:
SunOS Release 5.10 Version Generic_118833-17 64-bit
Copyright 1983-2005 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
Hardware watchdog enabled
Assertion failed: r == 0, file libscf.c, line 36
Feb 19 17:12:02 svc.startd[27]: restarting after interruption
Assertion failed: r == 0, file libscf.c, line 36
Feb 19 17:12:03 svc.startd[30]: restarting after interruption
Assertion failed: r == 0, file libscf.c, line 36
Requesting maintenance mode
now, i can't find the "libscf.c" file anywhere on my system... this when on maintenance mode... i also can't view the man pages or write to any files until i mount /... with /sbin/mount -o rw,remount /...
what could possibly cause this and what can i do to solve it? i've looked everywhere but no luck...