Dear all.
We have a very big issue on Attach HP EVA to IBM AIX powerpc singlepath.
the configurations on
lscfg -vl fcs2
fcs2 U789C.001.DQD8D74-P1-C2-T1 4Gb FC PCI Express Adapter (df1000fe)
Part Number.................10N7249
Serial Number...............1C91808105
Manufacturer................001C
EC Level....................D76626
Customer Card ID Number.....5773
FRU Number.................. 10N7249
Device Specific.\(ZM\)........3
Network Address.............10000000C98974AB
ROS Level and ID............02E8277F
Device Specific.\(Z0\)........2057706D
Device Specific.\(Z1\)........00000000
Device Specific.\(Z2\)........00000000
Device Specific.\(Z3\)........03000909
Device Specific.\(Z4\)........FFE01212
Device Specific.\(Z5\)........02E8277F
Device Specific.\(Z6\)........06E32715
Device Specific.\(Z7\)........07E3277F
Device Specific.\(Z8\)........20000000C98974AB
Device Specific.\(Z9\)........ZS2.71X15
Device Specific.\(ZA\)........Z1D2.70A5
Device Specific.\(ZB\)........Z2D2.71X15
Device Specific.\(ZC\)........00000000
Hardware Location Code......U789C.001.DQD8D74-P1-C2-T1
:wall:
---------- Post updated at 08:30 PM ---------- Previous update was at 08:21 PM ----------
I did this configurations like :
To prepare your IBM AIX system for MPIO installation:
-
Set up the EVA disks and SAN configuration for multipathing. For details, see the HP
StorageWorks SAN design reference guide on the following HP web site: -
Ensure that the Vdisks are presented to the system with host type IBM AIX.
-
Ensure that all I/O paths to a set of LUNs are connected to the same type of HBA.
-
Verify that no AntemetA solution software is installed. Check for the Antemeta filesets below and
remove them before continuing with this installation:
� devices.fcp.hdi.pdisk.rte
� devices.fcp.hdi.hsv100.rte
� devices.fcp.hdi.hsv110.rte
� devices.fcp.hdi.hsv200.rte
� devices.fcp.hdi.hsv210.rte -
Verify that your system has the required patches installed.
-
Download the devices.fcp.disk.HP.hsv.mpio.1.0.1.0.tar file from the following