Add new disk to Sun StorEdge 3310 RAID

UNIX Solaris
1

HI guys.
Bit of a noob so bear with me.

I have 2 new disks I want to add to my StorEdge 3310 but am getting lost in the steps. We have another 3310 (JBOD) that I was able to plug the disks into and they instantly showed up. Did a few minor commands after (drvconfig, devfsadm etc..) and I was good to partition the slices...

On our 3310 (RAID) I plugged them in and its not seeing them:

 
# format
Searching for disks...done
 
 
AVAILABLE DISK SELECTIONS:
       0. c1t0d0 <SUN36G cyl 24620 alt 2 hd 27 sec 107>
          /pci@9,600000/SUNW,qlc@2/fp@0,0/ssd@w21000004cfd967a7,0
       1. c1t1d0 <SUN36G cyl 24620 alt 2 hd 27 sec 107>
          /pci@9,600000/SUNW,qlc@2/fp@0,0/ssd@w21000004cfd964d1,0
       2. c2t0d0 <SUN-StorEdge3310-0325 cyl 35424 alt 2 hd 127 sec 127>
          /pci@8,600000/pci@1/scsi@4/sd@0,0

What steps do I need to perform to allow the server to see the 2 new added disks. (SEAGATES)

Thanks

2

you have to logon to the array...

Contents

3

So can I accomplish that by plugging a laptop into the serial port of the array? I did see some documentation about doing that.

What would the steps be after that?

4

you can use a serial line... but note, the default setting for this device is 38400 bauds! for the steps after connecting, use the documentation... haven't worked on such an array for years...

5

Used serial lin ebut still can't connect with hyperterminal.
Says I am connected and when I type anything just puts x's on the screen...

Any help would be appreciated.

Thanks

---------- Post updated at 01:16 PM ---------- Previous update was at 12:59 PM ----------

K I was able to get to a login screen using baud 9600 but not sure of the id and password. Is there a default one I can use?

---------- Post updated at 02:16 PM ---------- Previous update was at 01:16 PM ----------

Alright making progress.

After a lot of reading about the SCSI 3310 array I have determined there is a single bus configuration. I have added two 72 GB disks to the array and would like to set them up using sccli.

Does anyone know where I can locate that documentation in sun?