Hi gull04 & DukeNuke2
I've found a spare IDE DVD player. So I'm going to give it a try.
Also, DukeNuke2, I will probably have troubles trying net installation as my Sun Blade 1500 can't get any IP address from the network. No?
Best regards to all of you,
I'll be back soon to let you know what I've found.
---------- Post updated at 08:40 AM ---------- Previous update was at 07:58 AM ----------
Hi again, I'm back with good news this time :).
So, I've tried replacing the DVD player with another IDE one I had.
And.....
.... it finally boots \o/
So, on first boot I had warnings about labels. I ran the format utility and labelled it.
Reboot, wait for the {ok} prompt, plug the Ethernet cable and run "boot cdrom -s"
Here is the output
boot cdrom -s
Boot device: /pci@1e,600000/ide@d/cdrom@2,0:f File and args: -s
SunOS Release 5.10 Version Generic_147440-01 64 bits
Copyright .... All right reserved
Booting to milestone "milestone/single-user:default".
Configuring Devices
Using RPC Bootparams for network configuration information.
Attempting to configure interface bge0
Skipped interface bge0 (after 1 minute trying to configure it)
Requesting System Maintenant Mode
SINGLE USER MODE
#
So, the good news is that Solaris 10 Sparc DVD version finally boots
The bad news is that apparently I still have troubles with the network interface (really don't know why)
The other bad news is that I expected to get that screen and then select "1 Solaris interactive (default)", but for some reasons (network?) I just get a prompt #.
Actually looking on the internet what can I do from there.
If you have any ideas of what I should do/try, please let me know :).
Of course, you've all deserved a for your help since yesterday.
Thanks again a lot.
/edit
Sorry I'm being stupid, didn't realized that Single User Mode was only a prompt mode.
So, just typed "exit" and now i'm back to the installation.
Will let you know