Greetings!
After block level migration using an external appliance, the luns are getting reported as DGC-RAID5 and these luns are infact from the new storage. I have a query on changing the device Vendor info from DGC-RAID5 to HP3par in the format o/p only.
AVAILABLE DISK SELECTIONS:
2. c0t60002AC0000000000000000B0000xxxxd0 <DGC-RAID5-0430 cyl 51198 alt 2 hd 256 sec 16>
/scsi_vhci/ssd@g60002ac0000000000000000b0000xxxx
I am able to see the mpathadm and luxadm correctly reporting the device Vendor id as shown below.
luxadm display 20210002ac00xxxx DEVICE PROPERTIES for disk: 20210002ac00xxxx
Vendor: 3PARdata
Product ID: VV
Revision: 3213
Serial Num: 16xxxxx
Unformatted capacity: 103424.000 MBytes
Read Cache: Enabled
Minimum prefetch: 0x0
Maximum prefetch: 0xffff
Device Type: Disk device
Path(s):
/dev/rdsk/c0t60002AC0000000000000000B0000xxxxd0s2
Multipath definitions are configured ok and is reporting the actual paths.
However, format command reports them as DGC-RAID5 and adds a bit of confusion. Is there a way we can get the "format" command to get it reported correctly?
Thanks in advance!
BR,
Bhaskar