Hi,
based on your experience what is the most common IPMP configuration on a two nodes cluster for HA failover / scalable services?
...active-active, active-standby with probe-based failure detection etc.
Thanks
Hi,
based on your experience what is the most common IPMP configuration on a two nodes cluster for HA failover / scalable services?
...active-active, active-standby with probe-based failure detection etc.
Thanks
this depends on the service and the requirements... but i think the most used config is active-standy.
ok ...but to generalize and simplify a lot, is correct to say:
for HA failover services: active[+test address] - standby
for HA scalable services: active[+test address] - active[+test address]
no, it isn't.