How to enable Serial port on ILOM, when Network Port is enabled in parallel

UNIX Solaris
1

Hi Everyone,

In my environment, I have few T5220. On the iLOM Management Card, I have both Network and Serial port are cabled, I don't have any issues while I try to connect using Network Management port, but when I try to connect the serial port for the same server which is actually connected through a terminal server, authentication to the terminal server is successful and conformed port is opened, but cant able to view the console of the server.

So how do I need to make sure to enable the serial port on iLOM.

Thanks

2

the serial port on the server is enabled by default. maybe your terminal server settings are wrong or you are using a wrong cable.

1 Like
3

Thanks for your reply,
What setting do I need to verify from Terminal Server side.

4

9600,8,N,1

if you can, check with a notebook with a serial cisco cable (the baby blue ones) and a terminal software (putty, teraterm, hyperterm, tip, ...) if there is output from the serial server port. if this works you have to search on the TS side or the cables.