Adding Broastcaste i.p manually

kkarthik_kaja · February 25, 2011, 8:21pm

Hi,

I am trying to add one interface manually using plumb command. After that it is showing point to point communication.

But it should show broadcaste.

ce3: flags=1000851<UP,POINTOPOINT,RUNNING,MULTICAST,IPv4> mtu 1500 index 6
inet 10.136.11.225 --> 10.136.11.1 netmask ff000000
ether 0:3:ba:b3:c7:f2

I need to add broadcaste manually. pLease suggest

fpmurphy · February 25, 2011, 8:40pm

You need to unplumb the interface first. Then plumb the interface again followed by setting IP address, etc.

kkarthik_kaja · February 28, 2011, 1:12am

I have manually plumbed it but it is giving point to pint instead of broadcaste.

The same o/p has been pasted in trailing posts.

Please suggest